Remington mb4560 Instructions For Use Manual

Remington mb4560 Instructions For Use Manual

Touch control beard trimmer
Hide thumbs Also See for mb4560:

Advertisement

Touch Control Beard Trimmer
MB4560

Advertisement

Table of Contents
loading

Summary of Contents for Remington mb4560

  • Page 1 Touch Control Beard Trimmer MB4560...
  • Page 2 Thank you for buying your new Remington® product. Please read these instructions carefully and keep them safe. Remove all packaging before use. F IMPORTANT SAFETY INSTRUCTIONS Warning – for additional protection the installation of a residual current device (RCD) with a rated residual operating current not exceeding 30mA is advisable in the electrical circuit supplying the bathroom.
  • Page 3: Key Features

    C KEY FEATURES 1 3 position slide switch (Off/On/Lock motor on) 2 Cutting length controls 3 Digital display for: a. Battery level b. Length setting, mm c. Lock / unlock d. Speed level 4 Motorised comb 5 Mode Button 6 Tri-Boost system 7 Micro USB port 8 USB cable 9 Adaptor...
  • Page 4: Corded Use

    C GETTING STARTED Before the unit can be used for the first time, keep hands away from touch screen area and pull out the plastic tab marked with an arrow from the bottom of the unit. The plastic tab is only for shipping and can be discarded. , CHARGING YOUR APPLIANCE •...
  • Page 5: Using Touch Screen

    , CAUTION • Extended mains only use will result in the reduction of the battery life. , WARNING • The appliance can not be operated in corded mode while connected to a PC via the USB port. , CORDLESS USE • When the unit is switched on and fully charged, the product can be used in cordless mode for 50 minutes. F INSTRUCTIONS FOR USE • Always comb your beard or moustache with a fine comb before you start trimming. • Turn the product on by sliding the 3 position slide switch down to the middle position. This will turn the LCD display on and enable height adjustments and boost adjustments to be made.
  • Page 6: To Thin & Taper Beard/Moustache

    , Note: Trimmer comb must be attached to the groomer in order to use the hair length selector. , TO THIN AND TAPER THE BEARD/MOUSTACHE (DIAGRAM 1) • Use the touch screen to set the trimmer comb to the desired length setting. • The setting will appear on the length position indicator. If you are trimming for the first time start with the maximum trimming length setting.
  • Page 7: Care For Trimmer

    C CARE FOR YOUR TRIMMER , AFTER EACH USE • Ensure the appliance is switched off and unplugged from the mains before cleaning. • Brush the accumulated hair from the blades. Do not submerge the clipper in water. • To clean the unit, wipe with a damp cloth and dry immediately. • Only the attachment guide combs and trimmer blade may be removed from the product for cleaning. • Cleaning should only be done with a soft brush. , CLEANING CAUTIONS • Do not rinse under water.
  • Page 8: Battery Removal

    If you call the Service Centre, please have the Model No. to hand, as we won’t be able to help you without it. The Model No. can be found on the rating plate of the appliance. Replacement parts and accessories are available to buy at www.remington.co.uk/parts-accessories...
  • Page 9 Visit www.productregister.co.uk/remington. You must register within 28 days of purchase. Model No. MB4560 14/UK/ MB4560 T22-0002176 Version 03 /14 Remington® is a Registered Trade Mark of Spectrum Brands, Inc., or one of its subsidiaries. Spectrum Brands (UK) Ltd Fir Street, Failsworth,...

Table of Contents