Traxxas 39085 E-MAXX Owner's Manual page 14

To prevent loss of radio range
do not kink or cut the black wire,
do not bend or cut the metal tip,
and do not bend or cut the white
wire at the end of the metal tip.
Correct No No No
14 • E-MAXX BRUSHLESS
TRAXXAS TQ RADIO SYSTEM
i
3. Make sure your transmitter antenna is straight up, and then walk
away from the model with the transmitter until you reach the
farthest distance you plan to operate the model.
4. Operate the controls on the transmitter once again to be sure
that the model responds correctly.
5. Do not attempt to operate the model if there is any problem
with the radio system or any external interference with your
radio signal at your location.
Higher Speeds Require Greater Distance
The faster you drive your model, the more quickly it will near
the limit of radio range. At 60mph, a model can cover 88 feet
every second! It's a thrill, but use caution to keep your model
in range. If you want to see your model achieve its maximum
speed, it is best to position yourself in the middle of the truck's
running area, not the far end, so you drive the truck towards and
past your position. In addition to maximizing the radio's range,
this technique will keep your model closer to you, making it
easier to see and control.
No matter how fast or far you drive your model, always leave
adequate space between you, the model, and others. Never drive
directly toward yourself or others.
TQi Binding Instructions
For proper operation, the transmitter and receiver must be
electronically 'bound.' This has been done for you at the factory.
Should you ever need to re-bind the system or bind to an additional
transmitter or receiver, follow these instructions. Note: the receiver
must be connected to a 4.8-6.0v (nominal) power source for
binding and the transmitter and receiver must be within 5 feet of
each other.
1. Press and hold the transmitter's SET button as you switch the
transmitter on. The transmitter's LED will flash red slowly.
Release the SET button.
2. Press and hold the receiver's LINK button as you switch on
the speed control by pressing the EZ-Set button. Release the
LINK button.
3. When the transmitter and receiver's LEDs turn solid green, the
system is bound and ready for use. Confirm that the steering
and throttle operate properly before driving your model.
Steering Sensitivity (Exponential)
The Multi-Function knob on the TQi transmitter has been
programmed to control Steering Sensitivity (also known as
exponential). The standard setting for Steering Sensitivity is
"normal (zero exponential)," with the dial full left in its range of
travel. This setting provides linear servo response: the steering
servo's movement will correspond exactly with the input from
the transmitter's steering wheel. Turning the knob clockwise from
the left will result in "negative exponential" and decrease steering
sensitivity by making the servo less responsive near neutral, with
increasing sensitivity as the servo nears the limits of its travel range.
The farther you turn the knob, the more pronounced the change
in steering servo movement will be. The term "exponential" comes
from this effect; the servo's travel changes exponentially relative
to the input from the steering wheel. The exponential effect is
indicated as a percentage—the greater the percentage, the greater
the effect. The illustrations below show how this works.
Normal Steering Sensitivity (0% exponential)
In this illustration, the steering servo's travel (and with it, the steering
motion of the model's front wheels) corresponds precisely with the
steering wheel. The ranges are exaggerated for illustrative purposes.
Decreased Steering Sensitivity (Negative Exponential)
By turning the Multi-Function knob clockwise, the steering
sensitivity of the model will be decreased. Note that a relatively
large amount of steering wheel travel results in a smaller
amount of servo travel. The farther you turn the knob, the more
pronounced the effect becomes. Decreased steering sensitivity
may be helpful when driving on low-traction surfaces, when