Traxxas 39085 E-MAXX Owner's Manual
  1. Manuals
  2. Brands
  3. Traxxas Manuals
  4. Motorized Toy Car
  5. 39085 E-MAXX
  6. Owner's manual

Traxxas 39085 E-MAXX Owner's Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
MODEL 39085
owner
s manual
'

Advertisement

Table of Contents
loading

Related Manuals for Traxxas 39085 E-MAXX

Summary of Contents for Traxxas 39085 E-MAXX

  • Page 1 MODEL 39085 owner s manual ’...
  • Page 2 Radio Frequency (RF) Exposure Information The radiated output power of the Traxxas LP Device is below the Industry Canada (IC) radio frequency exposure limits. The antenna for this transmitter must not be co-located with any other transmitters except in accordance with FCC and Industry Canada multi-transmitter procedures. Co-location means having a separation distance of less than 20 cm between transmitting antennas.

  • Page 3: Before You Proceed

    Traxxas accompanying materials to prevent serious damage to your 6200 Traxxas Way All of us at Traxxas want you to safely enjoy your new model. Operate model. Failure to follow these instructions will be considered McKinney, TX 75070 your model sensibly and with care, and it will be exciting, safe, and fun abuse and/or neglect.

  • Page 4: Speed Control

    SAFETY PRECAUTIONS • Only use approved chargers for NiMH battery packs (such as the of the installation and/or use of LiPo batteries in Traxxas models. If you Traxxas EZ-Peak Plus Charger, part #2933). Do not exceed the have questions about LiPo battery usage, please consult with your local All instructions and maximum charge rate of 4 amps.

  • Page 5: Tools, Supplies And Required Equipment

    R/C toolbox: • Safety glasses • Traxxas Ultra Premium Tire Glue, part #6468 (CA glue) • Hobby knife • Side cutters and/or needle Foam battery...
  • Page 6 E-MAXX BRUSHLESS EDITION OVERVIEW Half Shaft Traxxas High- Electronic Speed Control Hex Hub Pivot Ball Axle Carrier Current Connector Pinion Gear Toe Link Battery Hold-Down Toe Link Battery Front Suspension Arm Spur Gear Rear Body Mount Motor Front Body Mount...

  • Page 7: Quick Start: Getting Up To Speed

    QUICK START: GETTING UP TO SPEED The following guide is an overview of the procedures for getting your model running. Look for the Quick Start logo on the bottom corners of Quick Start pages. The Quick Start Guide is not intended to replace the 1.

  • Page 8: Radio System

    It happens for a very short period as the signals from the electronic speed control and the motor Your model includes the latest Traxxas TQi 2.4GHz transmitter with Applying the Decals synch with each other. The VXL-3m is optimized to virtually Traxxas Link ™...
  • Page 9 When flow is constricted, energy is converted to heat and is voltage corresponds to the pressure that is forcing the water Correct lost. Traxxas power systems are optimized to reduce electrical through the hose. resistance and the resulting power-robbing heat.

  • Page 10: Transmitter/Receiver

    Weight with Wires ..........121g Connector Type ........6.5mm bullet Channel 2 MXL-6s Electronic Speed Control Battery Compartment Power Switch ** Accessory sensor port for use with TQi Docking Base (see Traxxas.com and included materials for more information) 10 • E-MAXX BRUSHLESS...

  • Page 11: Installing Transmitter Batteries

    The status LED does not indicate the Using Different Battery Configurations your model at the first sign of charge level of the battery pack installed in the model. If the Traxxas The battery hold- weak batteries (flashing red Link application is installed and running, there is a battery level “25”...
  • Page 12 Secure, long-lasting, and easy to grip, the Traxxas connector is engineered to extract all the power your battery has to give. Always turn your Plug in the batteries.
  • Page 13 TRAXXAS TQ RADIO SYSTEM • In order for the transmitter and receiver to bind to one another, USING THE RADIO SYSTEM the receiver in the model must be turned on within 20 seconds The TQi Radio System has been pre-adjusted at the factory. The Using Reverse: While driving, of turning on the transmitter.
  • Page 14 TRAXXAS TQ RADIO SYSTEM 3. Make sure your transmitter antenna is straight up, and then walk Steering Sensitivity (Exponential) away from the model with the transmitter until you reach the The Multi-Function knob on the TQi transmitter has been To prevent loss of radio range farthest distance you plan to operate the model.

  • Page 15: Setting Up The Antenna

    driving at high speed, or on tracks that favor sweeping turns ADJUSTING THE ELECTRONIC where gentle steering inputs are required. The ranges are SPEED CONTROL MXL-6s Specs exaggerated for illustrative purposes. The MXL-6s speed control should not need reprogramming with Cells: normal use;...

  • Page 16: Driving Your Model

    DRIVING YOUR MODEL Now it’s time to have some fun! This section contains instructions on 2. Drive normally. The slipper clutch should slip momentarily driving and making adjustments to your model. Before you go on, when accelerating aggressively on high-traction surfaces (you here are some important precautions to keep in mind.
  • Page 17 Do not use LiPo batteries in wet conditions. • Use batteries with the highest mAh rating you can purchase. • The Traxxas TQi transmitter is not water resistant. Do not subject • Use a high-quality peak-detecting charger. it to wet conditions such as rain.
  • Page 18 DRIVING YOUR MODEL Before Running Your Vehicle in Wet Conditions 4. Blow off the truck with compressed air (optional, but recommended). 1. Consult the section “After Running Your Vehicle in Wet Conditions” Wear safety glasses when using compressed air. before proceeding. Make sure you understand the additional 5.

  • Page 19: Receiver Box

    The excess wire will be bundled inside the receiver box. Label which wire is for which channel. 4. Apply small bead of silicone grease (Traxxas part #1647) to the wire clamp. 5. Install the wire clamp and tighten the two 2.8x8mm cap screws securely.

  • Page 20: Tuning Adjustments

    TUNING ADJUSTMENTS SUSPENSION TUNING We recommend using two-hole pistons with a range of oil viscosities from 30W to 50W Adjusting the Pivot Ball Caps For easier access to the (available from your hobby shop). The thinner The pivot ball caps should be adjusted rear-most shock mounting viscosity oils (30W or less) flow with less so that the pivot balls operate freely in...
  • Page 21 (A) to position (B). position of the shocks will allow for lower shock progression and the soft, plush feel that’s characteristic of a Traxxas Maxx Truck. Ride height is not affected by changes in the upper shock mounting position.

  • Page 22: Transmission Tuning

    (the direction is same carriers adjust the static camber. The pivot at all four corners). Note that Traxxas cannot recommend the use of other non-Traxxas wheels balls are protected by blue dust plugs. To the groove in the hex indicates with different specifications.

  • Page 23: Motor/Gearing

    TUNING ADJUSTMENTS MOTOR AND GEARING Adjusting Gear Mesh Gearing Compatibility Chart: The chart below shows a full range Incorrect gear mesh is the most The E-Maxx is equipped from the factory with a 68-tooth spur gear of gear combinations. This does NOT common cause of stripped spur and 17-tooth pinion gears.

  • Page 24: Dual Steering System

    E-Maxx. Optional steering servo horns are sold center line of the chassis (pointing to the rear of the truck). separately for use with non-Traxxas servos. 7. Connect the short steering link from the servo saver to the servo horn.

  • Page 25: Maintaining Your Model

    5. Check the mounting of the receiver and servo(s) and overtightening. If the bottom of the shock is leaking, then it speed control. is time for a rebuild. The Traxxas rebuild kit for two shocks is 6. Check the tightness of the wheel nuts with a wrench. part #2362.

  • Page 26: Tq I Advanced Tuning Guide

    The TQi radio system automatically keeps track of what vehicles it has bound iPod touch 3rd Generation 4mm + 3mm (7mm total) to and what settings were used for each--up to 30 models total! Traxxas Link iPod touch 4th Generation 4mm + 3mm + 2mm (9mm total)
  • Page 27 Many When the Multi-Function knob is set to device and the Traxxas Link application. All the features described racers set Dual Rate so they have only as much steering throw as...
  • Page 28 Press SET to delete the model. Press and hold MENU to Setting Lock turn them on and drive. With Traxxas Link Model Memory, return to driving mode. Once you’ve adjusted all of these settings the way you like...

  • Page 29: Menu Tree

    3. Press SET. The red LED will blink in single intervals to indicate Steering Dual Rate has been selected. Model Locking Press Unlock Traxxas-Link Press 4. Press MENU twice. The red LED will blink three times repeatedly to One Blink Green One Blink Red Four Blinks Green indicate Steering Percentage has been selected.
  • Page 30 ADVANCED TUNING GUIDE Set Multi-Function MENU TREE FORMULAS knob for STEERING Press/hold MENU Press SET Press SET to confirm Press/hold MENU SENSITIVITY (Expo) To select functions and make adjustments to the TQi transmitter without green LED blinks red LED blinks green LED blinks (x8) returns to driving mode referencing the menu tree, turn your transmitter on, find the function in the...
  • Page 31 ’ 6200 Traxxas Way, McKinney, TX 75070 1-888-TRAXXAS “Made for iPod” and “Made for iPhone” mean that an electronic accessory has been designed to connect specifically to iPod and iPhone, respectively, Made for · iPhone 4S and has been certified by the developer to meet Apple performance standards. Apple is not responsible for the operation of this device or its ·...

Table of Contents