Cisco Linksys WET610N Quick Installation Manual page 6

Installation WET61ON
"
• The available networks are
listed in the table. Select your
network, and then click ext.
(If your router supports Wi-Fi
Protected Setup, which is
indicated by the icon next
to the network name, then
proceed to the section, "Wi-Fi
Protected Setu p':)
If your network is not listed, select My network is not in this list, and
click Next. Proceed to step
o.
• If you r network does not use
wireless security, proceed to
step P.
If your network uses wireless
security, enter the security key
of your wireless network. Click
Next. Then proceed to step P.
O.
Configure the following:
ireless et or arne
{SSID}
Enter the name of your
wireless network.
Au hentication Type Select
the authentication used by your
wireless network.
Encryp ion ype Select
the encryption used by your
wireless network.
Security ey Enter the security key of your wireless network.
Click ext.
6
OTE: If you are connecting to your own wireless network, you
may want to configure wireless security on your router if you
have not already done so.
Wireless-N Ethernet Bridge with Dual-Band