Table of Contents
Advertisement
Test Pattern
This function is used to set the internal test
signal:Gray scale 1,Gray scale 2,:Gray scale
3,:Gray scale 4, Color bar, Red, Green, Bluw,
Cross hatch,White,Black and Gray.
*
Network
Function : PC controls projector via LAN.
Preparation:
1. Equipments: PC, projector, cables
2. Connection procedures:
Connect the projector to routers or switches of the LAN by direct or cross cable. If it fails to
connect PC and projector by parallel cable, please switch to cross cable as suggested.
3. After the computer is booted and the projector is plugged in, indicator lights of LAN interface
on will flash continuously.
Operation procedures:
1 Turn on the projector.
2 Obtain network address. DHCP set is displayed as On and obtain network address
automatically.( If familiar with network, you can set DHCP as Off and obtain network
address manually.)
3 Enter network settings menu.
(1) Press MENU button on remote control
to display screen menu. Press
button to select Expand, then press
OK button.
(2) Press button to select Network,
and then press OK button to enter the
newtork menu.
Test Pattern
PC adjust
Off
Gray scale 1
Display
Gray scale 2
Gray scale 3
Color adjust
Gray scale 4
Setting
Color bar
Red
Expand
Green
Blue
Info.
Cross hatch
Move
PC adjust
Network setting
Network information:
Display
MAC address:
IP address:
Color adjust
Setting
Expand
Info.
Move
Expand
Test Pattern
Next
Back
Network
000000000000
192.168.001.023
Next
Exit
45
Advertisement
Table of Contents
