D-Link DGS-3024 Manual page 139

The following fields may be set or viewed:
Parameter Description
Time Interval
Record Number
ExDefer
LateColl
ExColl
SingColl
Coll
CRCError
Show/Hide
Clear
DGS-3024 Gigabit Ethernet Switch Manual
Figure 10- 11. Tx Error Analysis window (table)
Select the desired setting between 1s and 60s, where "s" stands for seconds. The
default value is one second.
Select the number of times the Switch will be polled between 20 and 200. The default
value is 20.
Counts the number of packets for which the first transmission attempt on a particular
interface was delayed because the medium was busy.
Counts the number of times that a collision is detected later than 512 bit-times into the
transmission of a packet.
Excessive Collisions. The number of packets for which transmission failed due to
excessive collisions.
Single Collision Frames. The number of successfully transmitted packets for which
transmission is inhibited by more than one collision.
An estimate of the total number of collisions on this network segment.
Counts otherwise valid packets that did not end on a byte (octet) boundary.
Check whether or not to display ExDefer, LateColl, ExColl, SingColl, Coll, and CRC
errors.
Clicking this button clears all statistics counters on this window.
125