System Connections; Connecting/Using A Decoder - JVC HR-J648EH, HR-J648E, HR-J448E, HR-J248E Instructions Manual

SYSTEM CONNECTIONS

Connecting/
Using A
Decoder
TV Receiver
AV2 IN/DECODER
Back of
HR-J448E/
J248E
Satellite
antenna
Satellite tuner
RF Cable (provided)
TV Aerial
Cable
AV1 IN/OUT
Back of
HR-J648E/EH
Decoder
The AV2 IN/DECODER connector can be used as an input
terminal for an external decoder (descrambler). Simply connect
a decoder and you can enjoy the variety of programming that is
available through scrambled channels.
SELECT INPUT MODE
1
Set "AV2 SELECT" to "DECODER". (
CONNECT DECODER
2
Connect your recorder's AV2 IN/DECODER connector
to the decoder's Euroconnector using a 21-pin SCART
cable.
SET TUNER
3
Perform the procedure as described in "When Receiv-
ing A Scrambled Broadcast" on page 36.
NOTE:
When Connecting A Satellite Tuner . . .
. . . if you don't have a decoder connect the satellite tuner
directly to the video recorder's AV2 IN/DECODER connector.
. . . if you have a decoder, first connect the decoder to the
decoder input of the satellite tuner, then connect the satellite
tuner's output to the recorder's AV2 IN/DECODER connector.
Refer to the instruction book for the satellite tuner and decoder.
. . . set "AV2 SELECT" to "AV2". (
. . . to view a programme via the satellite tuner, select AU 2
mode by pressing NUMBER keys and/or TV PROG. so that
"AU-2" appears on the display panel.
33
EN
pg. 30)
pg. 30)