IBT Technologies MB860 User Manual page 45

Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC)
installed on the motherboard and you wish to use it. If you install an
add-in FDC or the system has no floppy drive, select Disabled in this
field. This option allows you to select the onboard FDD port.
Onboard Serial/Parallel Port
These fields allow you to select the onboard serial and parallel ports and
their addresses. The default values for these ports are:
Serial Port 1
Serial Port 2
Serial Port 3
Serial Port 4
Parallel Port
UART Mode Select
This field determines the UART 2 mode in your computer. The default
value is Normal. Other options include IrDA and ASKIR.
Parallel Port Mode
This field allows you to determine parallel port mode function.
SPP
EPP
ECP
PWRON After PWR-Fail
This field sets the system power status whether on or off when power
returns from a power failure situation.
3F8H/IRQ4
2F8H/IRQ3
3E8H/IRQ11
2E8H/IRQ10
378H/IRQ7
Standard Printer Port
Enhanced Parallel Port
Extended Capabilities Port
MB860 User' s Manual
BIOS SETUP
41