PERIODIC MAINTENANCE AND ADJUSTMENT
Replacing a turn signal light
bulb
1. Remove the turn signal light lens
by removing the screws.
1
1. Turn signal light lens
2. Screw
2. Remove the burnt-out bulb by
7
pushing it in and turning it counter-
clockwise.
EAU24213
2
1. Turn signal light bulb
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the
screws. NOTICE: Do not over-
tighten the screws, otherwise
the lens may break.
Replacing a license plate light
bulb
1
1. Remove the license plate light unit
1. Nut
2. Washer
3. Rubber damper
[ECA10681]
4. License plate light unit
2. Remove the license plate light lens
7-30
by removing the nuts, washers and
rubber dampers.
by removing the nuts and washers.
EAU24324