DV-545, DV-444-S, DV-444-K
6.3 NECESSARY ADJUSTMENT POINTS
When
Exchange Parts of Mechanism Assy
Exchange the Pickup
Exchange the Traverse Mechanism
Exchange the Spindle Motor
Exchange PCB Assy
Exchange PC Board
SSIB, LOAB, DVDM ASSY
∗
Purpose: To set the sweep which was correct with the
individual Traverse mechanism.
Be sure to perform the following step finally when replaced
Pickup, Traverse Mechanism and Spindle Motor.
GGF1067
Test mode
remote control
unit
(It is necessary when performed adjustment procedure Ÿ.)
52
Mechanical
point
Electric
point
Mechanical
point
Electric
point
Mechanical
point
Electric
point
Mechanical
point
Electric
point
ESC
CLEAR
Adjustment Points
∗ After adjustment, screw locks
~, Ÿ, !
with the Screw tight.
!
∗ After adjustment, screw locks
Ÿ, !
with the Screw tight.