AMT Datasouth Accel-7450 Manual page 5

Operational safety

Do not touch the print head immediately
after printing because it is too hot.

Do not put your finger under the tractor
cover while loading fanfold paper.
Cautions in setting up

Unpack the printer. Make sure that the
printer body and all accessories are
included in the package and no parts are
damaged.

Do not use the printer in a location
exposed to direct sunlight or close to a
heater or other heat generating
equipment.

Do not use the printer in a dusty location
or any location subject to sudden
changes in temperature and humidity.

Never try to print without a ribbon
cassette installed and paper loaded.

Take care not to twist the ribbon while
installing the ribbon cassette.

Push the lock levers of both tractors to
the LOCK positions firmly when loading
fanfold paper.
CAUTION

Do not put your finger on the tractor
gear, when using the rear tractor.
CAUTION

Place the printer on a rigid,
horizontal base in a location that is
free of vibration.

Before connecting or disconnecting
the interface cable, be sure to turn
off the printer.

Do not connect the printer to a non-
standard power source.
Rear Operating Clearance
 Fanfold Paper: 2" plus Paper Length

Manual Cut Sheets: Paper Length
Minus 9"

If the case or cover becomes dirty,
clean it with a soft cloth moistened
with a small quantity of neutral
detergent diluted with water. Never
use a hard cloth or volatile solvent
such as alcohol, thinner, or

Do not turn off the printer during
printing, as this may lead to a
malfunction.
2
ACCEL-7450
benzene.