Table of Contents
Advertisement
Cabling and Power Up
Setting Up the Customer Engineer Tool (PC)
If the CE Tool is a laptop using Reflection 1, ensure communications settings are in place, using the following
procedure:
1. From the Reflection 1 Main screen, pull down the Connection menu and select Connection Setup.
•
Select Serial Port.
•
Select Com1
•
Check the settings and change, if required.
Go to More Settings to set Xon/Xoff. Click OK to close the More Settings window.
•
Click OK to close the Connection Setup window.
2. Pull down the Setup menu and select Terminal (under the Emulation tab).
•
Select terminal type VT100 or VT102
•
Click Apply.
This option is not highlighted if the terminal type you want is already selected.
3. Click OK.
Connecting the CE Tool to the Local RS232 Port on the MP
This connection allows direct communications with the MP. Only one window can be created on the CE
Tool to monitor the MP. When enabled, it provides direct access to the MP and any partition.
Use the following procedure to connect the CE Tool to the Local RS-232 Port on the MP:
1. Connect one end of a null modem cable (9-pin to 9-pin) (Part Number 5182-4794) to the M cable connector
labeled CONSOLE.
2. Connect the other end of the RS-232 cable to the CE Tool.
52
Chapter 4
Advertisement
Table of Contents
