Table of Contents
Advertisement
INSTALLATION
2
CONNECT VIDEO RECORDER TO TV
Place the recorder on a stable, flat surface.
Back of TV
Aerial connector
21-pin AV input connector
(SCART)
Mains Power Cord
Mains outlet
RF CONNECTION
To Connect To A TV With NO 21-pin AV input connector
(SCART) . . .
1– Disconnect the TV aerial cable from the TV.
2– Connect the TV aerial cable to the ANT. IN jack on the rear
panel of the recorder.
3– Connect the provided RF cable between the RF OUT jack
on the rear panel of the recorder and the TV's aerial
connector.
ATTENTION
Do NOT Plug the mains power cord into a mains outlet until all connections are completed.
Do NOT press the
power before you start the Auto Set Up procedure described on page 6.
21-pin SCART Cable
(not provided)
Make this
connection if
your TV has a
21-pin AV input
connector (SCART) in
order to reduce the
possibility of interference.
And if you are using a stereo
TV, you will need this cable
in order to enjoy stereo
playback of videotapes.
button on the recorder or on the remote control to turn on the recorder's
AFTER YOU FINISH THIS STEP
RF Cable (provided)
AV1 IN/OUT
AV CONNECTION
To Connect To A TV with 21-pin AV input connector
(SCART) . . .
1– Connect the aerial, recorder and TV as per "RF
CONNECTION".
2– Connect an optional SCART cable between the AV1 IN/OUT
socket on the rear panel of the recorder and the TV's 21-pin
AV input connector (SCART).
TV Aerial Cable
(not provided)
ANT. IN
R
L
AUDIO
OUT
RF OUT
AV2 IN
PAUSE
Back of Recorder
Go to Step 3 – AUTO SET UP
5
Advertisement
Table of Contents
