Panasonic NE-2156 Service Manual page 18

NE-2156 / NE-2146 / NE-1656
1. Remove ceiling plate by gently moving the left and right
tabs inward while pulling the plate down and outward.
2. Using a small flat screwdriver or the like, remove two plastic
clips located on the antenna ring. Next turn the antenna ring
approx. 1/8 turn clockwise to unhook the tabs and pull off.
9.5. Replacement of floor shelf and
lower antenna
1. To remove the floor shelf, insert a screwdriver through the
small opening on the left side of the oven cavity and
carefully lift the floor shelf.
2. For removal of lower antenna, use the same procedure as
upper antenna.
9.6. Replacement of temperature
sensor (Thermal protector)
1. Cut 2 lead wires at the top of sensor terminals.
2. Remove 2 screws holding temp sensor and replace with
new one.
3. Solder the lead wires securely to the sensor terminals.
9.7. Disassembly of door assembly
1. Remove each 2 bolts holding upper and lower hinges.
2. Open the door and while pulling the door outward, work
upper and lower hinges out through the holes of the front
surface of oven.
3. Remove door C (choke cover) from door E by carefully
pulling outward starting from the upper right hand corner.
4. Remove 2 screws holding door handle and separate door A
from door E by carefully freeing catch hooks.
5. Remove door key, door key lever, door key spring and
handle pins from door E.
6. Assemble the door by taking the above steps in a reverse
order.
Replacement
18