Removing the System Cover
Remove the system cover as follows:
1. Disconnect from the system any cables that are attached to external devices, such
as the monitor, keyboard, and mouse (see
Caution – Pressing the power switch does not remove all power from the system; a
small voltage remains in the power supply. To remove all power from the system,
you must disconnect the system power cord.
2. Disconnect the system power cord to ensure all power is removed from the
system.
3. At the system back panel, remove the two screws that secure the cover.
4. Slide the cover back to the end of the system chassis and lift the cover off.
Attaching an Antistatic Wrist Strap
Caution – Always wear an antistatic wrist strap when handling internal
!
components to equalize all electrical potentials within the system.
Attach an antistatic wrist strap as follows:
1. Unwrap the first two folds of the wrist strap and wrap the adhesive side firmly
against your wrist.
2. Peel the liner from the copper foil at the opposite end of the wrist strap.
3. Attach the copper foil end of the wrist strap to the system chassis to provide
ground for electrostatic discharge (see
4
Sun Blade 100 CD-ROM or DVD-ROM and Hard Disk Drive Installation Guide • January 2002
).
FIGURE 1
).
FIGURE 1