Table of Contents
Advertisement
2. Turn the tray upside down on an antistatic mat.
3. Using a No. 2 Phillips screwdriver, replace the four screws securing the hard drive
to the hard drive tray.
4. Position the hard drive tray into the chassis.
Note – When you slide the hard drive tray back in, do not push against the ejection
lever or the tray will not properly latch. Push against the hard drive tray.
5. While ensuring that the cables are not damaged, slide the hard drive tray into the
chassis until the spring-loaded latch clicks into place.
6. Connect the hard drive IDE cable connector labeled Primary HDD to the primary
hard drive.
Note – Ensure that the cables are properly oriented by aligning the connector keys.
7. Connect the power cable to the hard drive.
8. Ensure that the cables will not be damaged when you replace the system cover.
9. Detach the wrist strap, replace the system cover, and power on the system as
described in "Finishing Component Installation" on page 14.
Installing a Secondary Hard Drive
The secondary hard drive option for the Sun Blade 100 system mounts next to the
primary hard drive on the hard drive tray (see
assembly is used with the secondary hard drive. Use the following procedure to
install the optional secondary hard drive.
1. Power off the system, remove the system cover, and attach an antistatic wrist strap
as described in "Preparing for Installation" on page 2.
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing them on any surface.
2. Lift the spring-loaded latch upward to release the hard drive tray from the chassis
(see
3. Pull the hard drive tray ejection lever away from the chassis.
10
Sun Blade 100 CD-ROM or DVD-ROM and Hard Disk Drive Installation Guide • January 2002
).
FIGURE 6
). The secondary IDE cable
FIGURE 6
Advertisement
Table of Contents
