Positioning The Projector - Epson PowerLite 420 Installation Manual

Installation.book Page 10 Monday, February 13, 2012 4:23 PM

4 Positioning the Projector

BrightLink 425Wi/435Wi and PowerLite 425W/435W can project up to 113 inches diagonally for a WXGA
image or 100 inches diagonally for an XGA image. BrightLink 430i and PowerLite 420/430 can project up to
106 inches diagonally for an XGA image. You can project onto a pre-installed whiteboard or directly onto a
plain wall. The height of the included wall mount determines the maximum image size and how high the
image appears on the wall or whiteboard. The distance of the projector from the wall (once it is mounted on
the adjustable arm of the wall mount) also affects image size and position.
If you are planning to project on a whiteboard, the image may not fill the entire board, depending on the
aspect ratio. If you match the image height to the board's height, gaps may appear on the sides of the board.
Refer to the tables on the following pages and install the mount and projector to project images at the
appropriate size. The values are only a guide. The recommended projection distance is 27.6 to 46.9 inches (70
to 119 cm).
A: Vertical tilt adjustment: 0 to -9.5°
B: Horizontal roll adjustment: 0 to ± 5°
C: Horizontal rotation adjustment: 0 to ± 5°
D: Horizontal slide adjustment:
0 to ± 1.8 inches (0 to ± 45 mm)
E: Vertical angle adjustment screw:
0 to 5.3 inches (0 to 134 mm) (arm length minimum)
0 to 9.1 inches (0 to 230 mm) (arm length maximum)
Adjustment unit
B
10
C
Center of lens
Projected image
A
Arm plate