Turning The Printer On/Off - SATO XL400e Operator's Manual

2.12 TURNING THE PRINTER ON/OFF

Before Turning Power Off
When removing power from the printer, you should first feed any printed labels or tags out of the
printer by pressing the EJECT key while the printer is On Line. Any tags printed but still in the printer
will be ejected, cut and the tag/label retracted to place the first print line under the head.
Note: The EJECT operation can be controlled via software commands from the host.
After the printed labels have been ejected from the printer, place the printer in the OFF LINE state
before removing power. If the label/tag position is not disturbed while power is off, then the first
printable label/tag will be in the correct position when power is reapplied. The Media Type setting is
retained in the printer even though power is removed. When power is reapplied, the first print line of
the tag/label will be correctly positioned under the print head.
XL400/410e Operator's Manual
TOTAL NUMBER OF LABELS PRINTED.
WILL INCREMENT FOR LABEL PRINTED
SINCE THE LAST TIME THE PRINTER WAS
TURNED ON.
TOTAL NUMBER OF LABELS PRINTED.
WILL INCREMENT FOR LABEL PRINTED
SINCE THE LAST TIME THE PRINTER WAS
TURNED ON.
Section 2: Installation
Page 2-21