Left Switch; Clutch Master Cylinder - Suzuki DL1000AL4 Owner's Manual

LEFT SWITCH

Insert the boss of left switch housing into the hole on
the handlebars.
Install the left switch assembly with two screws.
Pinching the lead wires in the parts can short or
break circuit.
Check the lead wire routing when assembling
the switch.
A: Boss
B: Hole
C: 5 × 25 mm screw

CLUTCH MASTER CYLINDER

Install the clutch master cylinder onto the handlebars.
NOTE:
• Install the holder in position according to the
mark "UP".
• Align the dot mark on the handlebars with the
master cylinder-to-holder fitting surface.
A: Holder
B: Clutch master cylinder
C: 6 × 22 mm flange bolt
D: 6 × 22 mm flange bolt
E: Dot mark
Tighten the clutch master cylinder mounting bolts to
the specified torque.
 Clutch master cylinder mounting bolt:
NOTE:
• First tighten the bolt A of the upper side with
specified torque and then tighten the bolt B of
the lower side.
• Make sure that the holder has no clearance at
the upper side.
A: 6 × 22 mm flange bolt
B: 6 × 22 mm flange bolt
C: Holder
D: Clutch master cylinder
E: Handlebars
11
NOTICE
10 N·m (1.0 kgf-m)