Receiving Radio Broadcasts; Tuning In Stations Manually; Using Preset Tuning - JVC RX-6500VBK Instructions Manual

Receiving Radio Broadcasts

You can browse through all the stations or use the preset function to go immediately to a particular station.

Tuning in Stations Manually

On the front panel ONLY:
1. Press FM/AM to select the band.
The MULTI CURSOR % / fi / @ / #
buttons can be now used for operating the
tuner.
• Each time you press the button, the band alternates between
FM and AM.
2. Press MULTI CURSOR % / fi
repeatedly until " – TUNING +"
appears on the display.
3. Press MULTI CURSOR @ / #
until you find the frequency you
want.
• Pressing @ decreases the frequency.
• Pressing # increases the frequency.
Notes:
• When you hold MULTI CURSOR @ / # in step 3, the frequency
keeps changing until a station is tuned in.
• When a station of sufficient signal strength is tuned in, the TUNED
indicator lights up on the display.
When an FM stereo program is received, the STEREO indicator
also lights up.
16

Using Preset Tuning

Once a station is assigned to a channel number, the station can be
quickly tuned. You can preset up to 30 FM and 15 AM stations.
FM/AM
To store the preset stations
Before you start, remember...
• There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
On the front panel ONLY:
1. Tune in the station you want to preset (see
"Tuning in Stations Manually").
If you want to store the FM reception mode for this station,
select the FM reception mode you want. See "Selecting the FM
MULTI CURSOR
Reception Mode" on page 17.
2. Press MEMORY.
MULTI CURSOR
"CH-" appears and the channel number position starts flashing
on the display for about 5 seconds.
3. Press MULTI CURSOR @ / # to
select a channel number while the
channel number position is
flashing.
Note:
You can use the 10 keys on the remote control to select the preset
number. When using the 10 keys, be sure that they are activated
for the tuner, not for the CD and others. (See page 29.)
4. Press MEMORY again while the
selected channel number is
flashing on the display.
The selected channel number stops flashing.
The station is assigned to the selected channel number.
5. Repeat steps 1 to 4 until you store all the stations you want.
To erase a stored preset station
Storing a new station on a used number erases the previously stored
one.
MEMORY
MULTI CURSOR
MEMORY