Getting Started; Before Installation; Checking The Supplied Accessories; Setting The Voltage Selector Switch - JVC RX-558VBK Instructions Manual

Getting Started

This section explains how to connect audio/video components and speakers to the receiver, and how to connect the
power supply.

Before Installation

General
• Be sure your hands are dry.
• Turn the power off to all components.
• Read the manuals supplied with the components you are going to
connect.
Locations
• Install the receiver in a location that is level and protected from
moisture.
• The temperature around the receiver must be between –5˚ and
35˚ C (23˚ and 95˚ F).
• Make sure there is good ventilation around the receiver. Poor
ventilation could cause overheating and damage the receiver.
Handling the receiver
• Do not insert any metal object into the receiver.
• Do not disassemble the receiver or remove screws, covers, or
cabinet.
• Do not expose the receiver to rain or moisture.

Checking the Supplied Accessories

Check to be sure you have all of the following items, which are
supplied with the receiver.
The number in the parentheses indicates quantity of the pieces
supplied.
• Remote Control (1)
• Batteries (2)
• AM Loop Antenna (1)
• FM Antenna (1)
• AC Plug Adaptor (1)
If anything is missing, contact your dealer immediately.

Setting the Voltage Selector Switch

Before connections, always set the voltage selector switch first if
necessary.
Set the correct voltage for your area with
the voltage selector switch on the rear panel.
Use a screw driver to rotate the switch so
the number the arrow is pointing at is the
same as the voltage where you are plugging
in the receiver.

Connecting the FM and AM Antennas

FM Antenna Connections
AM
LOOP
A. Using the Supplied FM Antenna
The FM antenna provided can be connected to the FM 75
COAXIAL terminal as temporary measure.
B. Using the Standard Type Connector (Not Supplied)
A standard type connector should be connected to the FM 75
COAXIAL terminal.
Note:
If reception is poor, connect the outside antenna.
Before attaching a 75 coaxial cable (the kind with a round wire
going to an outside antenna), disconnect the supplied FM antenna.
VOLTAGE SELECTOR
127V
110V
230
-240V
220V
A
A
N N
T E
A N
7 5
F M IA L
A X
C O
A M
A M
T
O P
E X
L O
FM Antenna
Extend the supplied FM antenna horizontally.
ANTENNA
FM 75
COAXIAL
Outside FM Antenna Cable
AM
EXT
B A
N N
T E
A N
7 5
F M IA L
A X
C O
A M
A M
T
O P
E X
L O
3