Mounting The Master Station - NuTone IM-3204 Series Installation Instructions Manual

INSTALLATION

Mounting the Master Station

Refer to Figure 3
1. Use two (2) #6 x 3/8" screws to attach each of the two (2) mounting brackets to the rough-in frame. Before tightening the screws at each
mounting bracket, slide the bracket so it is flush with the wall surface (flush with rough-in frame if the rough-in is installed after the wall
board). Tighten all four (4) screws.
Refer to Figure 4 & 5
2. For rough-in frames which are recessed into the wall opening, insert two (2) shoulder screws (provided) into the front two holes in the
rough-in frame. For rough-in frames which are mounted flush with the wall, insert two (2) shoulder screws (provided) into the back two
holes in the rough-in frame.
Refer to Figure 6
3. Attach the master station panel to rough-in frame by placing keyhole slots in both mounting hinges over screw heads of shoulder screw in
rough-in frame.
Refer to Figure 7
4. Slide the master station panel to the right, then forward until the panel is flush with the wall.
5. Leave the master station panel faced down to connect wiring.
ROUTE SPEAKER
WIRES THROUGH
OBLONG HOLE
FIGURE 4
(Continued)
FIGURE 5
4
AM/FM
ANTENNA
FIGURE 6
FIGURE 3
FIGURE 7