Connecting Other Equipment; Adjusting The Voltage Selector - JVC MX-J100 Instructions Manual

Connecting Other Equipment

You can connect an audio equipment — used only as a
playback device.
When you connect and use this equipment, refer also to its
manual.
Be sure that the plugs of the audio cords are color coded:
White plugs and jacks are for left audio signals, and red ones
for right audio signals.
• DO NOT connect any equipment while the power
is on.
• DO NOT plug in any equipment until all
connections are complete.
To connect audio equipment
110V-
127V
220V-
240V
Audio equipment
Connect the audio output jacks on the other equipment and
the AUX IN jacks on the rear, using an audio cord (not
supplied).

Adjusting the Voltage Selector

Before plugging in the unit, set the correct voltage for your
area with the voltage selector on the rear of the unit.
• DO NOT plug in before setting the voltage
selector on the rear of the unit and all connection
procedures are complete.
FM 75 COAXIAL
AM ANT
AUX I N
R L
SPEAKERS
IMPEDANCE 6-16 OHMS
+
L
–
–
R
+
To audio output
Using a tool with sharp tips such as a ballpoint pen, set the
voltage selector to the correct voltage range position
matching your local voltage. (See the back cover page.)
NOW, you can plug in the unit and other
connected equipment FINALLY!
To start the display demonstration
Press DEMO while the unit is turned off (on
stand by).
To stop the display demonstration, press any button.
– 8 –
FM 75 COAXIAL
AM
ANT
AUX I N
R L
SPEAKERS
IMPEDANCE 6-16 OHMS.
110V-
127V
+
220V- L
240V
–
–
R
+
AC CORD
110V-
127V
220V-
240V
FM 75 COAXIAL
AM ANT
AUX I N
R L
SPEAKERS
IMPEDANCE 6-16 OHMS.
110V-
127V
+
L
220V-
240V
–
–
R
AC CORD +
To a wall outlet
COUNTER
RESET
DEMO