Step 6: Attach The Oven To The Wall - Amana ACO1840AB Installation Instructions Manual

STEP 6: ATTACH THE OVEN TO THE WALL

You will need two people to lift this microwave.
Failure to use more than one person could
result in personal injury.
1. Carefully lift microwave oven and hang it on support tabs (See
Figure 26 at the bottom of the mounting plate. Reaching through
upper cabinet, thread power supply cord through the power
supply cord hole in the bottom of the upper cabinet. See Figure
30.
2. Rotate the microwave upward so the top of oven is against the
bottom of the upper cabinet or cabinet frame.
3. Drop the lock pin and washer assembly into hole N (left side
hole) and push the pin down as far as it will go.
See Figure 31.
4. Place washers over two 1/4"x3" bolts. Then insert a bolt down
through each hole in the upper cabinet bottom.
Tighten the bolts until the gap between the upper cabinet and
microwave oven is closed. See Figure 32.
5. Remove the lock pin and washer.
If wall-vented or room-vented installation is used, skip to
No. 6, 7.
INSTALLATION
WARNING
washer
- 21 -
power cord
power cord
hole
Figure 30
lock pin
Figure 31
Figure 32