Description; Introduction; Unpacking; Optional Accessories - AKG IVM4500 IEM User Instructions

Thank you for purchasing an AKG product. This Manual contains important instruc-
tions for setting up and operating your equipment. Please take a few minutes to
read the instructions below carefully before operating the equipment. Please
keep the Manual for future reference. Have fun and impress your audience!
• 1 SST 4500 stereo transmitter
• 1 SPR 4500 bodypack stereo receiver
• 1 pair of IP 2 earbuds with 3 pairs of ear molds
• 1 rod antenna
• 1 rack mounting kit
• 1 power supply
• 2 AA size dry batteries
• Check that the packaging contains all of the items listed above. Should any of
these items be missing, please contact your AKG dealer.
• SPC 4500 wideband antenna combiner
• SRA 2 W passive wideband directional antenna
• RA 4000 W passive wideband omnidirectional antenna
• PSU 4000 central power supply
• HUB 4000 Q network interface
• MK PS antenna cables
• Front panel mounting kit for supplied antenna 0110E01890
• BP 4000 2.4-V rechargeable battery pack
• CU 4000 charger for 2 receivers or BP 4000 battery packs
The SST 4500 is a stationary stereo transmitter designed to transmit a mono, stereo,
or dual-channel signal to the SPR 4500 bodypack stereo receiver. It allows you to
select one of 1200 frequencies within a 30-MHz band. In addition, it provides an in-
tegrated compressor, limiter, highpass filter, and a dedicated binaural room simu-
lator. You can use the transmitter as a standalone unit or install it in a 19" rack using
the supplied rack mounting kit.
1 2
1 RF ON/OFF VOLUME: Combined pushbutton switch for activating/deactivat-
ing RF power and rotary volume control for the headphone output.
2 HP OUT: TRS 1/4" jack for connecting a pair of headphones. The signal is iden-
tical to the audio signal fed to the RF section.
3 SETUP: Adjusts the transmitter parameters.Display: see next page.

2 Description

4
IVM
4500

Introduction

Unpacking

Optional
Accessories
SST 4500
Stationary Transmitter

Front Panel

Fig. 1: Transmitter front
3
panel and display.
Refer to fig. 1.
27