When Using Mac Os - Brother QL-570 Setup & Operation Manual

2. When using Mac OS

This section explains how to install P-touch Editor 5.0, Fonts, Auto Format Templates,
Clip Art, and the printer driver. After the driver is installed the driver configuration is
explained.
•
Until the installation of printer driver is completed, do not connect the machine to
your Macintosh
Network interface cable from your Macintosh
•
When installing the machine, log in as the administrator.
The following is the example for Mac OS
QL-XXX. Read "XXX" as your printer name. The printer names in the following screens
may differ from your purchased printer name.
1
Start the Macintosh
Double click the "QL_Series" (CD-ROM) icon.
2
Click the [Mac OS X] folder and double click the [P-touch Editor 5.0
Installer].
Follow the on-screen instructions.
3
After the installation is completed and
the screen shown right is displayed,
click [Done].
The installation of the P-touch Editor 5.0 is
completed.
Next, install the printer driver.
4
Open [Brother QL-XXX Driver] in [Mac OS X] folder. Double
click [Brother QL-XXX Driver.pkg] in your OS name folder.
The Driver Installer starts up. Follow the on-screen instructions.
5
When the installation is completed and
the message "Click Restart to finish
installing the software" is displayed,
click [Restart].
The Macintosh
The installation of the printer driver is completed.
®
®
. If it has been connected to it, pull out the USB interface cable/
®
, and insert the CD-ROM into the CD-ROM drive.
®
is restarted.
®
.
®
X 10.4.9. In the following steps, you will see
23
STEP
1
STEP
2
STEP
3
STEP
4