Gigabyte GA-MA790X-DS4 User Manual page 83

B. Installing Windows Vista
(The procedure below assumes that only one RAID array exists in your system.)
Step 1:
Restart your system to boot from the Windows Vista setup disk and perform standard OS installation
steps. When a screen similar to that below appears (RAID hard drive will not be detected at this stage),
select Load Driver. (Figure 6).
Step 2:
Specify the location where the driver is saved. Refer to the following two ways:
Method A:
Insert the motherboard driver disk into your system and browse to the following directory:
\Chipset\RS690\Vista\Packages\Drivers\SBDrv\SB6xx\RAID\LH
For Windows Vista 64-bit, browse to the LH64A folder.
Method B:
If you have copied the SATA RAID driver to a floppy disk following the instructions in "5-1-2," insert the
floppy disk and browse to the LH (for Windows Vista 32-bit) or LH64A (for Windows Vista 64-bit) folder
(Figure 7).
(Note) For AHCI drives, installation of Windows Vista does not require you to install the SATA AHCI
Downloaded from www.Manualslib.com
(Note)
driver in advance during the OS installation process.
manuals search engine
Figure 6
Figure 7
- 83 - Appendix