Table of Contents
Advertisement
Listening to FM, MW, and LW Broadcasts
Tuning in a Station
1
Press FM/AM.
The unit automatically turns on and tunes
in the previously tuned station (FM, MW
or LW).
• Each time you press the button, the
band changes among FM, MW, and LW.
2
Start searching for stations.
On the unit:
Press and hold TUNING + or
TUNING – for more than 1
second.
On the remote control:
Press and hold 4 or
¢ for more than 1 second.
The unit starts searching for stations
and stops when a station of sufficient
signal strength is tuned in.
If a program is broadcast in stereo, the
ST (stereo) indicator lights up.
To stop during searching, press TUNING + or TUNING –
(or 4 or ¢ on the remote control).
When you press TUNING + or TUNING –
(or 4 or ¢ on the remote control) briefly and repeatedly
The frequency changes step by step.
To change the FM reception mode
When an FM stereo broadcast is hard to receive or
noisy, press FM MODE on the remote control so that
"MONO" appears and the MONO indicator lights up
on the display. Reception improves.
To restore the stereo effect, press FM MODE
again so that "STEREO" appears on the diplay and the
MONO indicator goes off from the display.
In this stereo mode, you can hear stereo sounds when a
program is broadcast in stereo.
Presetting Stations
You can preset 30 FM, 8 MW, and 7 LW stations.
In some cases, test frequencies have been already memorized
for the tuner since the factory examined the tuner preset
function before shipment. This is not a malfunction. You can
preset the stations you want into memory by following the
presetting method.
• There is a time limit in doing the following steps. If the setting
is canceled before you finish, start from step 1 again.
On the unit ONLY:
1
Tune in the station you want to preset.
• See "Tuning in a Station" above.
2
Press SET.
3
Press PRESET + or PRESET –
to select a preset number.
4
TUNING
Press SET again.
The tuned station in step 1 is stored in the preset number
selected in step 3.
• Storing a new station on a used number erases the
previously stored one.
When you unplug the AC power cord or if a power
failure occurs
The preset stations will be erased in a few days. If this happens,
preset the stations again.
Tuning in a Preset Station
1
Press FM/AM.
The unit automatically turns on and
FM MODE
tunes in the previously tuned station
(FM, MW or LW).
• Each time you press the button, the
band changes among FM, MW, and
LW.
2
Select a preset number.
On the unit:
Press PRESET + or PRESET –.
On the remote control:
Press the number buttons.
Ex.: For preset number 5, press 5.
For preset number 15, press +10
For preset number 20, press
For preset number 25, press
For preset number 30, press +10, +10, then 10.
– 11 –
then 5.
+10, then 10.
+10, +10, then 5.
SET
PRESET
SET
PRESET
1
2
3
4
5
6
7
8
9
10
+10
Advertisement
Table of Contents
