License Plate Lamp - Chevrolet 2014 Traverse Owner's Manual

To replace one of these bulbs:
1. Open the liftgate. See Liftgate
on page 2-8.
2. Remove the convenience net,
if the vehicle has one.
3. Remove the two taillamp screw
covers.
4. Remove the two screws holding
the taillamp assembly in place.
5. Pull out the taillamp assembly.
6. Turn the bulb socket
counterclockwise and pull it
straight out to remove it from the
taillamp assembly.
7. Pull the old bulb straight out of
the bulb socket.
8. Push the new bulb straight into
the bulb socket.
9. Push the taillamp assembly back
into its original location.
When reinstalling the taillamp
assembly, make sure the pin on
the taillamp assembly lines up
and is inserted correctly into the
opening of the vehicle.
10. Reinstall the two screws that
hold the taillamp assembly in
place.
11. Reinstall the two taillamp screw
covers.
Vehicle Care

License Plate Lamp

To replace one of these bulbs:
1. Open the liftgate. See Liftgate
on page 2-8.
2. Push the left end of the lamp
assembly toward the right.
3. Turn the lamp assembly down to
remove it from the liftgate.
10-27