Ipv4; Lan Setup - Tenda D301 User Manual

When the connection is successful, you can access Internet.

4.2.3 LAN Setup

Here you can configure the LAN IP Address and Subnet Mask. This IP address is to be used to access the device's
settings through a web browser. Be sure to make a note of any changes you apply to this page.

IPv4

IP Address: The device's LAN IP address. The default setting is 192.168.1.1.

 Subnet Mask: The LAN subnet mask of the device. Combined with the IP address, the IP Subnet Mask allows a
device to know which other addresses are local to it, and which must be reached through a gateway or modem
router. You can change the subnet mask to fit your network.
 Enable IGMP Snooping: Check to enable the IGMP Snooping feature and select either of the following two
modes:
 Configure the second IP Address and Subnet Mask for LAN interface: If you want to configure two IP
addresses for the LAN interface, you can check this option and enter the second IP Address and Subnet Mask
manually.
 Disable DHCP Server: Click to disable the DHCP Server.
 Enable DHCP Server: Click to enable the DHCP Server.
 Start IP Address: Specify the start of the range for the pool of IP addresses in the same subnet as the router.
 End IP Address: Specify the end of the range for the pool of IP addresses in the same subnet as the router.
 Leased Time: The lease time is a time length that the IP address is assigned to each device before it is refreshed.
- 44 -
Wireless Modem Router User Guide