Dodge 2010 Caliber Owner's Manual page 194

"gATE" and "Oil Change Required" will only be dis-
played in the EVIC display. For additional information,
refer to "Electronic Vehicle Information Center (EVIC) —
If Equipped".
gASCAP
If the vehicle diagnostic system determines that the fuel
filler cap is loose, improperly installed, or damaged, a
"gASCAP" message will display in the odometer display
area. Tighten the fuel filler cap properly and press the
TRIP ODOMETER button to turn off the message. If the
problem continues, the message will appear the next time
the vehicle is started.
A loose, improperly installed, or damaged fuel filler cap
may also turn on the Malfunction Indicator Light (MIL).
LoW TirE
When tire pressure is low, the odometer display will
toggle between LoW and TirE for three cycles.
UNDERSTANDING YOUR INSTRUMENT PANEL 193
noFUSE
If the vehicle diagnostic system determines that the
Ignition Off Draw (IOD) fuse is improperly installed, or
damaged, a "noFUSE" message will display in the odom-
eter display area. For further information on fuses and
fuse locations refer to "Fuses" in "Maintaining Your
Vehicle".
CHAngE OIL
Your vehicle is equipped with an engine oil change
indicator system. The "CHAngE OIL" message will flash
in the instrument cluster odometer for approximately
12 seconds after a single chime has sounded to indicate
the next scheduled oil change interval. The engine oil
change indicator system is duty cycle based, which
means the engine oil change interval may fluctuate
dependent upon your personal driving style.
Unless reset, this message will continue to display each
time you turn the ignition switch to the ON/RUN
4