Comfort Glow CGD3018N Owner's Operation And Installation Manual page 15

INSTALLATION
Continued
Each log is marked with a number. These numbers will help you
identify the log when installing. It is very important to install these
logs exactly as instructed. Do not modify logs. Only use logs
supplied with heater.
1. Place the front log (#1) on the grate fingers. Make sure the
front log rests firmly between the grate fingers and the grate
base (see Figure 27).
2. Place the base of the middle log (#2) in the U-shaped slots of
the grate base. The cutout on the right of the middle log should
fit over the burner (see Figure 28). Make sure the front of the
middle log is resting on the tabs of the grate base.
3. Locate pins on the bottom of back log (#3). Slide these pins into
the holes in the grate base behind the burner (see Figure 29).
4. Locate holes on the bottom of crossover log (#4). Slide front
hole onto the left pin (CCL3924NT or CCL3930NTA) or middle
pin (CCL3018NT or CCL3018N) on the middle log (#2) and
the pin on the back log (#3). See Figure 30 for placement.
5. For CCL3924NT and CCL3930NTA Only:
on the bottom of crossover log (#5). Slide the pin into the hole
located in crossover log (#4). Slide the hole onto the pin on
front log (#1). See Figure 31.
For CCL3018NT and CCL3018N Only:
bottom of crossover log (#5). Slide the holes over the left pins
on middle log (#2) and front log (#1). See Figure 32.
6. Locate holes on the bottom of crossover log (#6). Slide these
holes onto the right pins located in middle log (#2) and front
log (#1). See Figure 33.
7.
For CCL3930NTA only:
over log (#7). Slide onto the pins located in crossover log (#6)
and middle log (#2). See Figure 34.
8. Add lava rock around base of heater if desired. Do not place
any lava rock on logs or burner.
Front Log (#1)
Grate
Fingers
Grate Base
Figure 27 - Installing Front Log
(#1) (CCL3930NTA Shown)
For more information, visit www.desatech.com
For more information, visit www.desatech.com
107123-01F
Locate pin and hole
Locate holes on the
Locate holes on the bottom of cross-
Middle Log (#2)
U-Shaped
Tab
Slot
Figure 28 - Installing Middle Log
(#2) (CCL3930NTA Shown)
Figure 29 - Installing Rear Log
(#3) (CCL3930NTA Shown)
Front Log (#1)
Figure 31 - Installing Crossover
Log (#5) (CCL3930NTA Shown)
Burner
Front Log (#1)
Figure 33 - Installing Crossover
Log (#6) (CCL3930NTA Shown)
INSTALLATION
Installing Logs (Cont.)
Pins
Pins
Log #2
Hole in
Grate
Base
Burner
Figure 30 - Installing Crossover
Log (#4) (CCL3930NTA Shown)
Crossover
Log (#4)
Front
Log (#1)
Figure 32 - Installing Crossover
Log (#5) (CCL3018NT and
CCL3018N Only)
Holes
Pins
Pins
Log #2
Figure 34 - Installing Crossover
Log (#7) to Model CCL3930NTA
Only
15
15
Log #4
Log #3
Crossover
Log (#4)
Crossover
Log (#6)
Middle
Log (#2)