Realignment Of A Transmitter; Pairing Of New Transmitters - Cobra SPYBALL 6829 User Instructions

It is powered by a Lithium CR 2032 3V-battery. When the battery is close to flat, the user is
warned by an additional flash of the turn indicators upon disarming.
Replace it as soon as possible and dispose of it at the appropriate collection points. Do not
delay the replacement of the battery, especially if you are using the Biker Recognition function,
because the system activates automatically when it does not receive any signals from the
transmitter!
Remark: to ensure good contact, take the new battery out of its packaging and place it into the
transmitter without touching it directly with your fingers (use a soft cloth).

2.1.Realignment of a transmitter

The transmitters that come with the kit are paired in advance and are already operational.
Realignment is needed when a paired transmitter is de-synchronised from the receiver.
This can happen if for example the transmitter is operated repeatedly outside the range of the
receiver because the transmitted code changes every time the alarm is turned on/off thanks to
an advanced method of random encryption (anti-scanning / anti-grabbing protection).
To realign, just press and hold down push-button n. 1 of the transmitter for at least 7 seconds.
A sequence of flashes of the turn indicators will confirm the success of realignment. If the
system is armed, it will disarm.

2.2. Pairing of new transmitters

In the event of loss of failure, one or two new transmitters can be paired as follows:
If the security system is armed, disarm it with the remaining transmitter (if it is available)
or enter your emergency disarming PIN code (see procedure in paragraph 16).
4