Kenmore 795.7403 Use & Care Manual page 38

8. FLUSH OUT THE TUBING
Turn the main water supply on and
flush out the tubing until the water
is clear.
Shut the water
off
at the water
valve after about one quart of
water has been flushed through the
tubing.
10. TURN THE WATER ON AT THE SHUTOFF VALVE
Tighten any connections that leak.
9. CONNECT THE TUBING TO THE REFRIGERATOR
Before making the connection to the refrigerator, be sure
that the refrigerator power cord is not plugged into the
wall outlet.
1. Remove the plastic flexible cap from the water valve.
2. Place the compression nut and ferrule (sleeve) onto the
end of the tubing as shown.
3. Insert the end of the copper tubing into the connection
as far as possible. While holding the tubing, tighten the
fitting.
Tubing Clamp _
1/4 in.
Compression
Nut _
Ferrule
(sleeve)
1/4 in. Tubing
l
erator
Connection
_CAUTION: Check to see if leaks occur at the water line
connections.
11. PLUG IN THE REFRIGERATOR
Arrange the coil of tubing so that it does not vibrate
against the back of the refrigerator or against the wall.
Push the refrigerator back to the wall.
12. START THE ICEMAKER
Turn the icemaker ON at the control panel.
The icemaker win not begin to operate until it reaches
its operating temperature of 15°F (-9°C) or below. It
will then begin operation automatically if the icemaker
button has been turned ON.
38