Reset/Restart Screen; System Operation Mode Overview - ZyXEL Communications WAP3205 User Manual

Note: If you uploaded the default configuration file you may need to change the IP
address of your computer to be in the same subnet as that of the default
WAP3205 IP address (192.168.1.2). See
on how to set up your computer's IP address.

12.8 Reset/Restart Screen

System restart allows you to reboot the WAP3205 without turning the power off.
Click Maintenance > Reset/Restart to open the following screen.
Figure 80 Maintenance > Reset/Restart
Click Restart to have the WAP3205 reboot. This does not affect the WAP3205's
configuration.

12.9 System Operation Mode Overview

The Sys OP Mode (System Operation Mode) function lets you configure your
WAP3205 as an access point, wireless client or both at the same time. You can
choose between Access Point Mode, Client Mode and Universal Repeater
Mode depending on your network topology and the features you require from
your device.
The following describes the device modes available in your WAP3205.
WAP3205 User's Guide
Chapter 12 Maintenance
Appendix C on page 167 for details
129