Playing Back A Tape - JVC 0303MWMMDWJEM Instructions Manual

Playing Back a Tape

You can play back type I tapes.
1
Push ) (PUSH OPEN).
The cassette holder opens.
2
Put a cassette in with the exposed part of the tape
down.
3
Push ) (PUSH OPEN) gently to close the cassette
holder.
When the unit is turned on, the TAPE
appears on the display.
4
Press TAPE 2 3.
Playback starts (if the unit is in standby, the unit
automatically turns on).
To change the tape direction, press TAPE 2 3.
• Each time you press the button, the tape direction
changes as follows:
: Plays the front side (left to right).
: Plays the reverse side (right to left).
TAPE indicator
TAPE
Tape direction (left to right)
When the tape plays to the end, the deck automatically
stops if the reverse mode is set to
play both sides—Reverse mode" on the right column.)
41
) (PUSH OPEN)
Cassette holder
Cassette holder
indicator
Reverse mode
and tape direction
indicators
or . (See "To
To stop during play, press 7.
To fast-wind to the left, press 4.
To fast-wind to the right, press ¢.
To remove the cassette, push ) (PUSH OPEN).
The TAPE indicator goes off.
DO NOT push ) (PUSH OPEN) during tape play.
To play both sides—Reverse mode
You can set the deck to play just one side or both sides of a
tape once, or both sides continuously.
Press REV. MODE.
• Each time you press the button, the reverse mode
changes as follows:
: Plays back only one side (front or reverse).
: Plays back the front and reverse sides once.
: Plays back both front and reverse sides
continuously.
• The use of the C-120 or thinner tape is not
recommended, since characteristic deterioration
may occur and this tape easily jams in the pinch
rollers and the capstans.
• You can also play back type II and type IV tapes;
however, the sound quality (tone) may not be
reproduced properly.