Factory Mode Adjustments; Entering Factory Mode; How To Access Service Mode; Using The Customer Remote - Samsung LN26A330J1D Service Manual

4. Troubleshooting

4-3. Factory Mode Adjustments

4-3-1 Entering Factory Mode

To enter 'Service Mode' Press the remote -control keys in this sequence :
- If you do not have Factory remote - control
Power OFF

4-3-2 How to Access Service Mode

Using the Customer Remote

1. Turn the power off and set to stand-by mode
2. Press the remote buttons in this order; POWER OFF-MUTE-1-8-2-POWER ON to turn the set on.
3. The set turns on and enters service mode. This may take approximately 20 seconds.
4. Press the Power button to exit and store data in memory.
- If you fail to enter service mode, repeat steps 1 and 2 above.
5. Initial SERVICE MODE DISPLAY State
ADC
ADC Target
ADC Value
Option BYTE
ADJUST
W/B
W/B Movie
EPA standard
FBE3
VDEC
Scaler
Sharpness
PE
Sound
Dynamic Contrast
PDP Option
- "T-PEONAUSC-1000" and "T-PEONASS-1000" are firmware.......
over version 2000 means Micronas FRC firmware.
6. Buttons operations withn Service Mode
Menu
Direction Keys /
Direction Keys /
Source
4-20
MUTE 1
Expert Settings
Expert D-Settings
Expert Gray Scale
Expert C-Space
Expert Others
CHECKSUM
RESET
T-CRLAUSC-00xx
0050 6628 00CD 1510
Micom / VER. / Month/ Day / Year
Full Menu Display/Move to Parent Menu
Item Selection by Moving the Cursor
Data Increase / Decrease for the Selected Item
Cycles through the active input source that are connected to the unit
8 2 Power On