Servicing Instructions; Electrical Information - Stanley EH6883 User Manual

SERVICING INSTRUCTIONS

Removal of Covers
Remove the self tapping screws and slide the Heating Unit from outer
housing, access to all components is then available.
Burner
Model 38 MJ/h Heater
Circular Stainless Steel Burner: 64mm diameter
86mm in length
Burner Ports: 6 rows of 50 x O 1.43
Burner tube: Length 105mm
Diameter 25mm
Inlet diameter 13mm
Ignition
Press button ignition
Flame Safeguard
"CH 20psi. Chant CSA K-80" Electro Magnet and Thermocouple
Overheat System
Two Thermo Electric Switches marked:
"HF KSD020 1 250V-10A"
Switching point 72 degrees Centigrade
Solonoid Value
"CEME 55IOND3,3 SGI AIF 230V 50Hz P 6 Bar DN 3,3"
Adjustments
Pilot Nil
Aeration. Fixed.
Ignition. (Spark Gap) 6mm
ELECTRICAL
The heater is supplied with a 220-240V AC electrical power cord with
a 3 pin plug. This plug must only be connected to an earthed power
supply.
IMPORTANT
This product is fitted with a sealed electrical connection plug that is
compatible with the heater, the mains supply for Australia and meets
the requirements of international standards. This heater must be
connected to a supply voltage that is equal to that stated on the rating
label. If the mains connection plug or power cord becomes damaged
it must be replaced with a complete assembly that is identical to the
original, and this must be replaced by an authorised service centre. If
in doubt always consult a qualified electrician.
Rating Label
Fan heater
Voltage
Input Wattage
10
EH6883
220-240V AC - 50Hz
130W