JVC RX-6100VBK Instructions Manual page 25

4. Adjust the speaker output levels.
• To adjust the center speaker level, press
CNTR –/+ (from –10 dB to +10 dB).
• To adjust the left rear speaker level, press
REAR•L –/+ (from –10 dB to +10 dB).
• To adjust the right rear speaker level, press
REAR•R –/+ (from –10 dB to +10 dB).
5. Press TEST again to stop the test
tone.
On the front panel:
You can also use the buttons on the front panel to adjust the
Surround modes. However, no test tone is available when using the
buttons on the front panel. So, make adjustments while listening to
the sound of the source played back.
1. Press SURROUND to activete an
appropriate Surround mode —
PRO LOGIC, DOLBY DIGITAL
or DTS SURROUND.
• Each time you press the button, the Surround mode turns on
and off alternately.
• When "PRO LOGIC" is selected, the Ÿ PRO LOGIC
indicator lights up on the display.
2. Adjust the speaker output levels.
1) Press ADJUST repeatedly until one of
the following indications appears on
the display.
"CENTER LEVEL":
To adjust the center speaker level.
"REAR L LEVEL":
To adjust the left rear speaker level.
"REAR R LEVEL":
To adjust the right rear speaker level.
• Once you have pressed ADJUST,
MULTI CURSOR % / fi can be also
used for selecting the speaker.
2) Press MULTI CURSOR @ / # to
adjust the selected speaker output level
(from –10 dB to +10 dB).
3) Repeat 1) and 2) to adjust the other
speaker output levels.
JVC Theater Surround adjustments
CNTR
3
4
Before you start, remember...
• Make sure that you have set the speaker information correctly
(see page 12).
• There is a time limit in doing the following steps. If the setting is
REAR•L
canceled before you finish, start from step 1 again.
5 6 • You cannot adjust the rear speaker output levels when you have set
"REAR SPK" to "NONE." See page 12.
• You cannot adjust the center speaker output level and center tone
MENU ENTER
when you have set "CENTER SPK" to "NONE." See page 12.
REAR•R
From the remote control:
7
8
/P
1. Press SURROUND MODE
repeatedly until "THEATER"
TEST
appears on the display.
0
• The Ÿ PRO LOGIC and DSP indicators
also light up on the display.
2. Press SOUND.
The 10 keys are activated for sound adjustments.
3. Press TEST to check the speaker
output balance.
"TEST TONE L" starts flashing on the
SURROUND
display, and a test tone comes out of the
speakers in the following order:
TEST TONE L
(Left front speaker)
Notes:
• You can adjust the speaker output levels without outputting the
test tone.
ADJUST
• No test tone comes out of the center speaker when "CENTER
SPK" is set to "NONE" (see page 12).
• No test tone comes out of the rear speakers when "REAR SPK"
is set to "NONE" (see page 12).
MULTI CURSOR
TEST TONE C
(Center speaker)
TEST TONE LS TEST TONE RS
(Left rear speaker)
SURROUND
MODE
SOUND
TEST
0
TEST TONE R
(Right front speaker)
(Right rear speaker)
23