Chevrolet Equinox 2015 Owner's Manual page 228

cruise control will automatically
disengage. See Traction Control/
Electronic Stability Control on
page 9-32. If a collision alert occurs
when cruise control is activated,
cruise control is disengaged. See
Forward Collision Alert (FCA)
System on page 9-37. When road
conditions allow you to safely use it
again, cruise control can be turned
back on.
If the brakes are applied, cruise
control is disengaged.
(On/Off): Press to turn cruise
control on or off.
(Cancel): Press to disengage
cruise control without erasing the
set speed from memory.
RES/+ (Resume/Accel): If there is
a set speed in memory, move the
thumbwheel up briefly to resume to
that speed or hold upward to
accelerate. If cruise control is
already active, use to increase
vehicle speed.
SET/ (Set/Coast): Move the
thumbwheel down briefly to set the
speed and activate cruise control.
If cruise control is already active,
use to decrease speed.
Setting Cruise Control
If the button is on when not in
use, SET/ or RES/+ could get
bumped and go into cruise when not
desired. Keep turned off when
cruise control is not being used.
1. Press to turn the cruise
system on.
Driving and Operating
2. Get up to the speed desired.
3. Move the thumbwheel toward
SET/ and release it. The
desired set speed briefly
appears in the Driver Information
Center (DIC) display.
4. Remove foot from the
accelerator.
Resuming a Set Speed
If the cruise control is set at a
desired speed and then the brakes
are applied or is pressed, the
cruise control is disengaged without
erasing the set speed from memory.
Once the vehicle reaches about
40 km/h (25 mph) or more, move the
thumbwheel up toward RES/+
briefly. The vehicle returns to the
previously set speed.
9-35