User Display Operation - American Water Heater PowerVent Use & Care Manual

Installing the User Display
11. The Water Heater Mounting Bracket features a
wiring slot on the top flange and an opening for the
wire. Pass the thermostat wire though the Water
Heater Mounting Bracket opening.
12. Clean any dust or dirt from water heater jacket to
allow proper tape adhesion.
13. Remove tape backing and carefully attach to the
heater jacket above the Rheem logo. Allow the
thermostat wire to be positioned in the wire slot
located on the bracket top flange.
14. The User Display will be mounted to the plastic
Water Heater Mounting Bracket.
15. Separate wall plate from the User Display by
removing battery cover and carefully pull wall plate
from display.
NOTICE: The battery backup option is not available
on this model.
User Display Features
Your water heater includes a user display for easy
local or remote water heater programming. The
user display features:
• Water heater temperature setpoint control
• L arge, clear, backlit display is easy to read-
even in the dark
• Displays relative available hot water
• Service needed indicator.
20
Water Heater
Mounting Bracket
Battery
Cover
User User Display
Display Mounting Bracket
Hot Water
Availability
16. Replace battery cover.
17. Attach display wall plate to heater bracket using
the two #6 x ½" Type A screws provided in User
Display Mounting Kit. Wire should pass through
display wall plate opening.
18. GO TO STEP 27.
19. Remote mounting will not require the Display to
Heater Bracket or Display Mounting Tape. The
bracket may be kept for future use or recycled.
20. Choose mounting location and route thermostat wire
to this location.
21. Separate wall plate from the User Display by
removing battery cover and carefully pull wall plate
from display.
22. Replace battery cover.
23. Pass thermostat wire through wire hole in wall plate.
24. Use mounting holes on wall plate to mark wall hole
locations.
25. Drill 3/16" holes and install wall anchors if required.
26. Use two #6 x 1" Type A screws provided in the User
Display box to attach wall plate to surface.
27. Connect thermostat wire to wall plate as follows:
• T op Terminal - GREEN - Data
Communication
• M iddle Terminal - RED - Power
• B ottom Terminal - WHITE - Common
28. Attach Thermostat Display to wall plate.
!
ATTENTION: Leave peel off screen protector on
the User Display for customer to review and remove.
30. Connect power to water heater
31. Turn on water heater and allow to heat.
32. Check thermostat display for proper display and
function.
Setpoint Temperature
Scald
Warning
Error
Code
Caution: Risk of Scalding
Increases with Hotter Water
Est. Hot SERVICE
Water NEEDED
Error
88
ON
VAC
Heat
Heat
Done Mute
Indication
Left/Right Keys
Max Setpoint
Temperature
Up/Down
Keys
Very Hot
C
B
A
Hot
•
•
•
Low
Max Setting
Clear Mode
Vacation Mode