Selecting The Fm Reception Mode - JVC RX-430VBK Instructions Manual

Tuning in a Preset Station
TUNER/BAND
FM/AM
PRESET SEA MODE
1 2 3
TEST DELAY
SURR MODE
4 5 6
– +
REAR
7/P 8 9
– +
CENTER
10 +10

Selecting the FM Reception Mode

TUNER/BAND
Page 17
To cancel a stored preset station
Storing a new station on a used number erases the previously stored one.
CAUTION:
The preset channels may be erased in the following cases:
POWER to set it in the —OFF position.
• When you press
• When you unplug the power cord.
• When a power failure occurs.
On the front panel:
1. Press TUNER/BAND so that the Control % % % % % / fi fi fi fi fi / @ @ @ @ @ / # # # # # buttons work for tuner settings.
The lamp above the button lights up.
2. Press Control % % % % % / fi fi fi fi fi until "–PRESET+" appears on the display.
3. Press Control @ @ @ @ @ / # # # # # to select a preset channel.
Each time you press the button, the preset channels change.
• Pressing Control @ changes preset channel in decreasing order.
• Pressing Control # changes preset channels in increasing order.
From the remote control:
1. Press FM/AM.
The last received station of the last selected band is tuned in.
Each time you press the button, the band alternates between FM and AM (MW/LW).
2. Press 10 keys to select a preset channel number.
For channel number 5, press 5. For channel number 15, press +10 then 5.
For channel number 20, press +10 then 10. For channel number 30, press +10, +10 then 10.
You can change the FM reception mode while receiving an FM broadcast.
On the front panel only:
1. Press TUNER/BAND so that the Control % % % % % / fi fi fi fi fi / @ @ @ @ @ / # # # # # buttons work for tuner settings.
The lamp above the button lights up.
2. Press Control % % % % % / fi fi fi fi fi until "FM MODE" appears on the display.
3. Press Control @ @ @ @ @ / # # # # # to select either "FM AUTO" or "FM MONO."
• Normally select "FM AUTO."
• When an FM stereo broadcast is hard to receive or noisy, select "FM MONO."
FM AUTO When a program is broadcast in stereo, you will hear stereo sound; when in monaural,
you will hear monaural sounds. This mode is also useful to suppress static noise between
stations.
The MUTE AUTO indicator lights up on the display.
FM MONO Reception will be improved although you will lose the stereo effect.
In this mode, you will hear noise while tuning into the stations.
The MUTE AUTO indicator goes off on the display.
Note:
You can store the FM reception mode for each preset station.