JVC LVT1140-004A Instructions Manual page 40

Operating Other Manufacturers' Video Equipment (Only for RX-6042S)
To change the transmittable signals for
operating another manufacturer's VCR
1 Press and hold STANDBY/ON
2 Press VCR.
3 Enter a manufacturer's code using buttons 1 – 9,
and 0.
Manufacturer
JVC
Emerson
Gold Star
Hitachi
Mitsubishi
NEC
Panasonic
Philips
RCA
Samsung
Sanyo
Sony
Zenith
* "01" is the initial setting.
4 Release STANDBY/ON
Now you can perform the following operations on the VCR:
STANDBY/ON VCR: Turn on and off the VCR.
VCR CH +/–:
After pressing VCR, you can perform the following operations
on the VCR:
3:
Start playing.
REW:
Rewind the tape.
FF: Fast-forward the tape.
7:
Stop playing or recording.
8: Pause playing. To resume, press 3.
REC PAUSE: Enter recording pause.
To start recording, press this button then 3.
5 Try to operate your VCR by pressing
STANDBY/ON VCR.
When your VCR turns on or off, you have entered the correct
code.
If there are more than one code listed for your brand of
VCR, try each one until the correct one is entered.
36
VCR.
Codes
01*, 02, 03
10, 22
11
04
12
21
07, 13
09
05, 06
20
17, 18, 19
14, 15, 16
08
VCR.
Change the TV channels on the
VCR.
To change the transmittable signals for
operating another manufacturer's DVD player
1 Press and hold STANDBY/ON
2 Press DVD.
3 Enter a manufacturer's code using buttons 1 – 9,
and 0.
Manufacturer
JVC
Panasonic
Philips
Pioneer
Sony
Toshiba
Yamaha
* "01" is the initial setting.
4 Release STANDBY/ON
Now you can perform the following operations on the DVD
player:
STANDBY/ON DVD: Turn on and off the DVD player.
After pressing DVD or DVD MULTI, you can perform the
following operations on the DVD player:
3:
Start playing.
4:
Return to the beginning of the current (or previous)
chapter (or fast reverse for some models).
¢:
Skip to the beginning of the next chapter (or fast
forward for some models).
7:
Stop playing.
8: Pause playing. To resume, press 3.
After pressing DVD (or DVD
MULTI), these buttons can be used
for the DVD menu operations.
Note:
For detailed menu operations, refer to
the instructions supplied with the discs
or the DVD player.
5 Try to operate your DVD player by pressing
STANDBY/ON DVD.
When your DVD player turns on or off, you have entered the
correct code.
Manufacturers' codes are subject to change without notice.
If they are changed, this remote control cannot operate the
equipment.
DVD.
Codes
01*
02
04
03
05
06
07
DVD.
2
4 6
MENU
7/P 8
ENTER
10