Switch Settings; Connectors; Installation; Pushbutton Switch - NEC Electra Elite IPK Installation And Maintenance Manual

Document Revision 4
___________________________________________________________________________________
2.2
SW1
OFF
2.3
2.4
2.5
___________________________________________________________________________________
1 - 4

Switch Settings

The IAD(8)-U( ) ETU has two switches that are described below.
Switch S1 is a Press to Reset switch.
Switch S2 is a Card Configuration switch. Refer to
ETU Switches.
Reserved
SW2 SW3
OFF OFF
1~3 always OFF
(Reserved) ESI(8)-U( ) ETU
simulation - must

Connectors

This ETU has the following connectors:
P1
J1, J10, J11
J5
J6

Installation

The IAD (8)-U( ) ETU can be installed in any KSU slot that supports the
applicable simulated ETU.

Pushbutton Switch

S1 is the reset switch.
Table 1-3 IAD(8)-U( ) ETU Switches
Auto Sense No. of Ports
SW4
ON
Auto Card
Discovery
Number of Voice
Selection - for
Ports - always ON
to enable 8 ports
be set to ON
Connects to the backboard
Reserved for future use
RJ-45 Ethernet connector for future use
Default RJ-45 Ethernet connector
MEGACO Station
Table 1-3 IAD(8)-U( )
ESI(8)-U10 ETU Mode
of Operation
SW5 SW6
ON ON
Mode Selection to
show simulated ETU
Electra Elite IPK IAD(8)-U( ) ETU
SW7 SW8
OFF OFF