Watching Tv - Sony KLV-26S200A Service Manual

Watching TV

Watching TV
1
1
Press 1 on the TV (top side) to switch on
the TV.
When the TV is in standby mode (the 1 (standby)
indicator on the TV (front) is red), press "/1 on
the remote to switch on the TV.
2
Press the number buttons or PROG +/- to
select a TV channel.
To select channel numbers 10 and above using the
number buttons, enter the second digit within two
seconds (available only if "1 Digit Direct" is set to
"Off").
14
GB
2
2
Additional operations
To Do this
Turn off the TV Press "/1.
temporarily
(Standby mode)
Press %. Press 2 +/- to set the
Turn on the TV
from Standby mode volume level.
without sound
Turn off the TV Press 1 on the TV (top side).
completely
Adjust the volume Press 2 + (increase)/
- (decrease).
Mute the sound Press %. Press again to restore.
Return to the Press
previous channel
watched (for more
than five seconds)
Access the Program Press MENU, select Program
index table List by pressing
channel by pressing
press
Note
Even if you press the 1 on the TV (top side) to turn it off, a
small amount of current continues to flow. Pull the AC plug
out of the wall jack to turn the TV off completely.
To access Text
Press /. Each time you press /, the display changes
cyclically as follows:
Text t Text over the TV picture (mix mode) t No
Text (exit the Text service)
To select a page, press the number buttons or PROG
+/-.
To hold a page, press
To reveal hidden information, press
Tips
• Ensure that the TV is receiving a good signal, or some text
errors may occur.
• Some TV channels broadcast a Text service. For
information on the use of the service, select the index page
(usually Text page 100).
• When four colored items appear at the bottom of the Text
page, Fastext is available. Fastext allows you to access
pages quickly and easily. Press the corresponding colored
button to access the page.
.
F f
, then press
/
. Next, select the desired
F f
/ , then
.
.
.