Table of Contents
Advertisement
SCAN
Radio
You can either scan all the frequencies on
a band or scan only the preset stations for
that band.
To scan the preset stations: Quickly push
and release "SCAN." If you hear a beep,
you held the button too long, and the radio
will scan all the frequencies. The radio will
tune in the next preset station up the
band, stay there for a few seconds, and
then move to the next preset station. To
select a station, push "SCAN" a second
time.
To scan all the frequencies: Push "SCAN"
until you hear a beep. The radio will find
the next station up the station band, stay
there for a few seconds, and then scan
again. To select a station, push "SCAN" a
second time.
Cassette player
The cassette player scan feature is similar
to the radio scan feature and uses the
same button.
Push "SCAN". "SCAN" will appear on the
display. The player will fast forward to the
next cassette track, play it for 12 seconds,
and then scan again. To select a track,
push "SCAN" a second time. If the player
reaches the end of one side of a cassette
tape, it will continue scanning on the other
side.
82
WWW.MANUALS.WS
Compact disc player
The compact disc player scan feature is
similar to the radio scan feature.
Push "SCAN". "SCAN" will appear on the
display. The compact disc player will play
the next track for 10 seconds, then scan
again. To select a track, push "SCAN" a
second time. If the player reaches the end
of the disc, it will continue scanning at
track 1.
SKIP
The skip feature allows you to fast forward
past long stretches of blank tape. This is
especially useful at the end of cassettes.
Push "SKIP". "SKIP" will appear on the
display. The cassette player will keep
track of how much blank space it plays.
Any time it has played about 10 seconds
of blank tape, it will automatically fast for-
ward to the next track and begin to play.
Push the button a second time to turn off
the skip feature.
ST (Stereo reception) display
Your radio automatically changes to ste-
reo reception when a stereo broadcast is
received. "ST" appears on the display. If
the signal becomes weak, the radio re-
duces the amount of channel separation
to prevent the weak signal from creating
noise. If the signal becomes extremely
WWW.MANUALS.WS
weak, the radio switches from stereo to
mono reception.
TAPE
Push "TAPE" to switch from radio or com-
pact disc operation to cassette operation.
If the audio system is off, you can turn on
the cassette player by pushing "TAPE". In
both cases, a cassette must already be
loaded in the player.
TREB (Treble)
This knob lets you adjust the treble level.
Push "BASS/TREB" so that it pops out of
its retracted position. Turn the knob to ad-
just the treble. Push the knob back into its
retracted position.
TUNE
Tuning
Your Toyota has an electronic tuning radio
(ETR).
Push and release the " " (up) or "v"
(down) side of "TUNE" to step up or down
the station band. (If you hear a beep, you
held the button too long and the radio will
go into the seek mode.)
Seeking
In the seek mode, the radio finds and
plays the next station up or down the sta-
tion band.
To seek a station, push and hold the " " or
"v" side of "TUNE" until you hear a beep.
Do this again to find another station.
Advertisement
Table of Contents
