ViewSonic VG150m-1 Service Manual page 5

This equipment has been tested and found to comply with the limits of Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates and can radiate radio frequency energy, and if
not installed and used in accordance with the instructions, may cause harmful interference to radio
communication. However, there is no guarantee that the interference will not occur in a particular installation.
If this equipment does cause unacceptable interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of following measures
Reorient or relocate the receiving antenna.
Increase the separation between equipment and receiver.
Connect into an outlet on circuit different from that to which the receiver is connected.
Consult the dealer or an experience radio/TV technician for help.
To assure continued FCC compliance the user must use a grounded power supply cord and the provided
shielded video interface cable with bonded ferrite cores. Also, unauthorized changes or modifications to
ViewSonic products will void the user s authority to operate this device. Thus ViewSonic will not be held
responsible for the product and its safety.
This device complies with the requirements of the ECC directive 89/3366/EEC with regard to
Electromagnetic compatibility.
Caution: Use a power cable properly grounded. Always use the AC Mains cords listed below for each area
USA
Canada
Germany
Switzerland
Britain
Japan
In other areas, use AC cord which meets the local safety standards.
ViewSonic Corporation
FCC Statement
FCC Warning
CE Certification
Safety Guidelines
(UL)
(CSA)
(VDE)
(SEV)
(BASE/BS)
(Electric Appliance Control Act)
2 Confidential - - Do Not Copy VG150m/mb