Timer Recording; Express Timer Programing - JVC HR-A47U Instructions Manual

24
EN
Express Timer
Programing
Turn on the VCR and the TV, and select the VCR
channel 3 or 4 (or AV mode) on the TV.
1
4
DAILY
7
3
4
1
2 8
POWER
2 3
2
5 6
WEEKLY
8 9
9
0
4
6
5
7
8
You can directly program the VCR's timer to record up to
8 broadcasts, as far as a year in advance. Remember, the
clock must be set before you can program the timer (
pg. 8 or 10).
1
Load a cassette
Make sure the record safety tab is intact. If not,
cover the hole with adhesive tape, then load it
into the VCR.
The VCR turns on, and the counter is reset,
automatically.
2
Access Program screen
Press PROG.. (If no
program is stored,
"PROGRAM 1"
appears.)
3
Set program start time
Press START +/–
repeatedly to enter the
time you want
recording to start.
Press and hold START
+/– to increase the
time in 30-minute
intervals.
4
Set program stop time
Press STOP +/– repeatedly to enter the time you
want recording to stop.
Press and hold STOP +/– to increase the time in
30-minute intervals.
5
Set program date
Press DATE +/–. (The current date is displayed on
the screen. The date you enter appears in its
place.)
6
Set channel number
Press CH +/–.
Holding down CH +/– rapidly changes the
channel numbers.
If you receive your programs through a cable
box, select the cable box output channel — the
channel on which you view the cable box
programs on the TV.

TIMER RECORDING

PROGRAM 1
START STOP
– –:– –AM = – –:– –AM
DATE CH
– –/– –/– – – – – SP
PRESS (+/–, SP/EP, 8=DAILY,
9=WEEKLY), THEN (0K)
PRESS (PROG.) TO END
PROGRAM 1
START STOP
= – –:– –AM
8:00 AM
DATE CH
– –/– –/– – – – – SP
PRESS (+/–, SP/EP, 8=DAILY,
9=WEEKLY), THEN (0K)
PRESS (PROG.) TO END