Evf Block, Rear Cover, Power Terminal - Hitachi DZ-MV100A Service Manual

3.4 EVF Block, Rear Cover, Power Terminal (Fig. 3-4)
Caution when disassembling:
Be careful not to damage any of the connector cables (flat cables).
3.4.1 EVF block (A)
(1) Disconnect one flat cable on the ANA circuit board (D).
(2) Move the EVF in the direction of the arrow (pull it out and tilt it up), and remove the two screws holding the EVF block (A).
3.4.2 Rear cover (B), Power terminal (C)
(3) Disconnect one flat cable on the ANA circuit board (D).
(4) Remove LSP shield (E) that is fixed by double-sided adhesive tape.
(5) Remove the two screws holding the rear cover (B).
(6) Release the two tabs, and remove the power terminal (C) from the rear cover (B).
A : EVF Block
B : Rear Cover
C : Power Terminal
D : ANA Circuit Board
E : LSP Shield
E
(3)[Type-a]
(2)
(1)[Type-b]
A
(2)
Fig. 3-4
(4)
B
D
(5)
C
(6)
E2 - 9