Setting An Indoor Unit Address And Installation Option - Samsung AM009FN1DCH/AA Service Manual

- Setting an indoor unit address and installation option

■ Setting an indoor unit installation option (suitable for the condition of each installation location)
1. Check whether power is supplied or not.
- When the indoor unit is not plugged in, there should be additional power supply
in the indoor unit.
2. The panel(display ) should be connected to an indoor unit to receive option.
3. Set the installation option according to the installation condition of an air
conditioner.
- The default setting of an indoor unit installation option is "020010-100000-200000-300000".
- Individual control of a remote controller(SEG20) is the function that controls an indoor unit individually when there is more
than one indoor unit.
4. Set the indoor unit option by wireless remote controller.
SEG1
0
SEG7
1
SEG13
2 External control
SEG19
Individual control of a
3
remote controller
1WAY/2WAY/4WAY MODEL : Drain pump(SEG8) will be set to 'USE + 3minute delay' even if the drain pump is set to 0.
1 WAY/2WAY/4WAY,DUCT MODEL : Number of hours using filter(SEG18) will be set to '1000hour' even if the SEG18 is set to
exept for 2 or 6.
If you input a number other than 0~4 of the individual control of the indoor unit(SEG20), the indoor is set as "indoor 1".
SEG5 central control option is basically set as 1 (Use), so you don't need to set the central control option additionally.
However, if the central control is not connected but it doesn't indicate an error message, you need to set the central control
option as 0 (Disuse) to exclude the indoor unit from the central control.
Samsung Electronics
SEG2 SEG3
2 RESERVED
SEG8 SEG9
Drain pump Hot water heater
SEG14 SEG15
External control
output
SEG20 SEG21
Heating setting
compensation
SEG4
Exterior temperature
Central control
sensor
SEG10
Opening the
Electronic heater electronic expansion
SEG16
S-Plasma ion
SEG22
EEV opening of an
indoor unit stopped
during oil return or
Defrost operation.
Troubleshooting
Indoor Unit
1(L)
F2
2(N) F1
SEG5 SEG6
FAN RPM
compensation
SEG11 SEG12
Master / Slave
valve
SEG17 SEG18
Number of hours
Buzzer
using filter
SEG23 SEG24
- Human sensor
4-11